Cabot's Exterior Clear Oil Based
Zoom
Cabot's Exterior Clear is an exterior polyurethane that provides a high gloss marine varnish. This clear varnish is perfect for exterior doors, windows and trims. Designed to provide resistance against weathering, mould and moisture damage, it provides supreme durability with a foolproof 3-coat system. Available in gloss or satin.
| Areas |
|
|---|---|
| Sizes |
|
| Application |
Brush 
Spray |
| Touch Dry |
4 hours
|
| Recoat |
12 hours
|
| Coverage |
12 m2/L |
| Cleaning |
Turps
|
Cabot's Exterior Clear is not suitable for
Hot tip!
- Scrub damp timber with Cabot’s New Timber Prep, following the label instructions.
- This draws out tannins and oils, so you can skip the 4–6 week weathering period.
- After using New Timber Prep, wash the surface with Cabot’s Deck Clean, following the label instructions.
- Use the squeegee on Cabot’s Deck Prep brush to remove any excess water from the surface.
- Allow the timber to dry for at least 1 hour before coating.
- Note: Cooler conditions may slow down drying time.
- Strip the surface back to bare timber.
- Use a paint stripper or sand thoroughly until all coatings are gone.
- Prepare a solution of Cabot’s Deck Clean as per the label instructions.
- Apply to the timber, scrub well, and rinse thoroughly.
- Use Cabot’s Deck Clean following the label instructions.
- Sprinkle water on the timber.
- If water beads on the surface, repeat the cleaning process.
- If water absorbs into the timber, it’s ready for coating.
Hot tip!
- For best results, sand timber back to fresh substrate.
- Use Cabot’s Deck Clean.
- Follow the label instructions carefully.
Apply using Brush or Spray.
- Stir thoroughly with a broad, flat paddle before and during use.
- Brush in the direction of the grain.
- Apply 3 liberal coats, allowing 12 hours drying time between each.
- Lightly sand the surface after each coat for a smooth finish.
Regular inspection of all coated surfaces is recommended. Pay particular attention to sharp edges.
Clean the surfaces with Cabot's Deck Clean as per label instructions.
Apply Cabot's Exterior Clear following label instructions.
Cabot's Exterior Clear Oil Based
Superior 3 Coat System
UV Protection
Dirt and Mould Resistant
Enhance timber grain
Select colour range
Colour - Clear
Sheen - Satin
Timber type - Meranti
Colour - Clear
Sheen - Satin
Timber type - Western Red Cedar
Colour - Clear
Sheen - Satin
Timber type - Merbau
Cabot's Exterior Clear Oil Based
Calculate total usage
If you are unsure how much product you need, please use our product calculator. Please note minimum length/width is 1 metre and maximum is 50 metres.