Cabot's CFP Floor Water Based
Zoom
Cabot's CFP Floor Water Based is a clear floor coating suitable for all interior timber parquetry, cork and engineered flooring. This non-yellowing water based floor finish is highly durable and fast drying. No sanding is required on pre-coated timber, saving you time and hassle! It can even be used with Cabot's Water Based Stain & Varnish to add colour to your timber floors.
| Areas |
|
|---|---|
| Sizes |
|
| Application |
Brush
Roller
Pad
|
| Touch Dry |
30 minutes
|
| Recoat |
3 hours
|
| Coverage |
16 m2/L |
| Cleaning |
Water
|
Note: No sanding is required for pre-coated timber floors; however, the preparation steps outlined below must be followed.
Please note
- Remove stains, dirt, wax, grease and oil with mineral turpentine.
-
If the surface has been polished, remove all polish using a suitable floor polish remover.
- Sand the surface smooth using 180–240 grit sandpaper, working only in the direction of the grain.
- Remove all sanding dust before proceeding.
-
Thoroughly clean the surface with Cabot’s Floor Clean and allow it to dry completely.
- Apply one coat to a small test area and allow to dry for 3 hours.
-
Press sticky tape firmly onto the test area and pull off quickly.
-
If the coating lifts, sand back to a sound surface before continuing.
Hot tip!
Apply with 6-10mm nap roller, Brush or Pad applicator
Hot tip!
- Stir thoroughly with a broad, flat paddle before use and during application.
-
Using a brush, cut in around the edges of one section at a time.
-
Apply using a pad applicator, good quality brush, or a 6–10 mm nap roller.
-
Work along the length of 3–4 boards, maintaining a wet edge to prevent lap marks.
-
Allow to dry for a minimum of 3 hours.
-
For best results, lightly sand to remove any grain raise using 240‑grit sandpaper.
-
Remove all sanding dust.
-
Apply the second and third coats following the same method as above.
- Apply 3 coats, allowing 3 hours between coats.
- Apply 2 coats, allowing 3 hours between coats.
- If staining is required, apply 1 coat of CFP Floor Water Based as a sealer.
-
Apply 1–2 coats of Cabot’s Stain & Varnish Water Based using a 6–10 mm nap microfibre roller.
-
Finish with 2 coats of Cabot’s CFP Floor Water Based, following the application instructions outlined above.
Hot tip!
Cabot's Wood Floor Cleaner is recommended for regular cleaning.
Once your timber floors have become excessively scratched, it's time for a re-coat with Cabot's CFP Floor Water based.
Cabot's CFP Floor Water Based
Resists stains & scratches
Fast recoat
Low odour
Non yellowing
Select colour range
Colour - Clear
Sheen - Matt
Timber type - Victorian Ash
Colour - Clear
Sheen - Matt
Timber type - Spotted Gum
Colour - Clear
Sheen - Matt
Timber type - Jarrah
Cabot's CFP Floor Water Based
Calculate total usage
If you are unsure how much product you need, please use our product calculator. Please note minimum length/width is 1 metre and maximum is 50 metres.