Cabot's Cabothane Clear Oil Based
Zoom
Cabot's Cabothane Clear Oil Based is durable and hard-wearing oil based polyurethane, designed for doors, windows, trims and furniture. This interior timber varnish will enhance the natural grain of timber providing a long-lasting finish, and resists stains and scratches. It can also act as a clear topcoat over Cabot's Interior Stain Oil Based.
Also available in a convenient 300g spray option.
| Areas |
|
|---|---|
| Sizes |
|
| Application |
Brush
Roller 
Pad
|
| Touch Dry |
2 hours
|
| Recoat |
6 hours
|
| Coverage |
16 m2/L |
| Cleaning |
Turps
|
Hot tip!
To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions.
- Thoroughly clean the surface with Cabot's Floor Clean and allow to dry. Sand with 180 - 240 grit sandpaper and remove all traces of sanding dust.
- Apply one coat to a small test area. Allow to dry for 6 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back to bare timber.
- If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions.
For best results, remove back to bare timber using a paint stripper, or sanding. For exterior surfaces only, clean with Cabot's Deck Clean following label instructions.
Brush, Spray
Hot tip!
- Stir thoroughly with a broad flat paddle before and during use.
- Apply with a good quality brush or spray gun. If spraying, back brushing is recommended. If brushing, always brush in the direction of the grain.
- Allow to dry for a minimum of 6 hours then lightly sand using 240 grit paper. Remove all sanding dust.
- Apply the 2nd & 3rd coats as above, lightly sanding with 240 grit paper between each coat.
Once your coating has worn and deteriorated, it's time for a re-coat.
1. Thoroughly clean the surface with Cabot's Floor Clean and allow to dry. Sand with 180 - 240 grit sandpaper and remove all traces of sanding dust.
2. Apply one coat to a small test area. Allow to dry for 6 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back to bare timber.
3. If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions.
Cabot's Cabothane Clear Oil Based
High durability
Resists stains & scratches
Enhances timber grain
Reduced odour
Select colour range
Colour - Clear
Sheen - Satin
Timber type - Victorian Ash
Colour - Clear
Sheen - Gloss
Timber type - Victorian Ash
Colour - Clear
Sheen - Satin
Timber type - Jarrah
Colour - Clear
Sheen - Gloss
Timber type - Jarrah
Cabot's Cabothane Clear Oil Based
Calculate total usage
If you are unsure how much product you need, please use our product calculator. Please note minimum length/width is 1 metre and maximum is 50 metres.