Cabot's Danish Oil

Zoom

Cabot's Danish Oil is an easy to apply oil for all interior furniture, doors, windows and trim. Applying danish oil will protect your timber whilst enhance the natural grain, leaving an abrasion resistant finish.

Areas	All interior timber furniture Doors Windows Trim and Timber blinds
Sizes	500mL 1L 4L
Application	Brush roller
Touch Dry	3 hours
Recoat	8 hours
Coverage	10 m²/L
Cleaning	Turps

Downloads

Product Data Sheet

Safety Data Sheet

Note: Fill nail holes, cracks and other defects with Cabot's Wood Tone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable polish remover.

Hot tip!

Previously coated interior timber with highly visible scratches, imperfections or surfaces that are severely worn must be sanded prior to coating.

Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.

Remove back to bare timber using a paint stripper or sanding. Remove all traces of sanding dust.

Do not apply this product if the temperature is below 10°C or above 35°C.

How to Restore Your Interior Timber Furniture

Hot tip!

Do not shake can.

Stir Thoroughly

Use a broad, flat paddle to stir the product thoroughly before and during use to ensure even consistency.

Apply First Coat

Apply a full, even coat using a brush, roller, or rag.

Allow to Dry

Let the first coat dry for 8 hours.

Sand Between Coats

Lightly sand the surface with 240 grit sandpaper.
Make sure to remove all sanding dust before proceeding.

Apply Second Coat

Use the same method as above.

Build a Higher Sheen Finish

Apply another coat of Danish Oil if required.
Allow 8 hours drying time between coats.
Lightly sand between coats using 240 grit sandpaper.

When the finish appears tired or dull, it's time for a re-coat.

Clean the Surface

Use Cabot's Floor Clean, following the label instructions, to thoroughly clean the surface.

Sand Lightly

Lightly sand the surface with 240 grit sandpaper.
Remove all traces of sanding dust before proceeding.

Apply

Apply 1–2 coats of Cabot's Danish Oil, following the label instructions for best results.

Cabot's Danish Oil

Nourishes & protects

Abrasion resistant

Enhances natural grain

Easy to apply

Select colour range

Select size Calculate how much product you need

Find online

Find a store

Before

After

COATS

All colours displayed on this page show 2 coats on Victorian Ash, Jarrah and Merbau.

Colour Accuracy: Due to image limitations, colours are a general guide only and do not represent the actual colour. Please test your colour selection at home on a timber cutoff of the same timber you will be coating before coating your timber.

Stock levels and product variants may vary across retailer websites due to ongoing inventory changes. Please review the retailer’s product page carefully before completing your purchase.

Buy at Bunnings

Buy at Inspirations Paint

If you are unsure how much product you need, please use our product calculator. Please note minimum length/width is 1 metre and maximum is 50 metres.

Length (metres)*

Width (metres)*

Coats*

The number of coats is a general guide only. Actual product requirements may vary based on surface type, condition and preparation.

Your approx need

Your measurements

Amount needed

This usage calculator provides a general guide only. Actual product requirements may vary based on surface type, condition and preparation, and application method.