We've all been there. You're getting ready to host a gathering when it hits you that time is running out and guests will arrive in under an hour. A quick glance at your deck, the space you planned to entertain, shows it's looking worse for wear. Fear not. With Cabot's EasyDeck™, you can quickly and easily refresh the look of your timber decking and be back on your deck in 40 minutes*.
Before you start, check that your existing coating is in good condition and not flaking, as Cabot's EasyDeck™ is designed for use over water-based coatings that are already in good condition. If you notice signs of deck damage such as loss of gloss, colour fade, cracking timber, or water absorbing into the surface, a protective recoat with Cabot's Aquadeck is recommended, followed by a 30 day wait before using Cabot's EasyDeck™.
*Conditions of 25°C and 50% relative humidity. More humid or cooler conditions will need longer drying times.
Slide on the Cabot's EasyDeck™ Applicator Pad and close the latch firmly. Insert the pole and twist the collar until the pole is securely attached.
Shake the Cabot's EasyDeck™ Maintenance Coat 1.5L bottle for 1 minute. Replace the bottle cap with the dispensing nozzle and firmly insert into the applicator.
Slide on the Cabot's EasyDeck™ Applicator Pad and close the latch firmly. Insert the pole and twist the collar until the pole is securely attached.
Shake the Cabot's EasyDeck™ Maintenance Coat 1.5L bottle for 1 minute. Replace the bottle cap with the dispensing nozzle and firmly insert into the applicator.
Get coating
Unhook the trigger and slowly squeeze the handle 10 times until the applicator pad is soaked.
Lift up the applicator, let the liquid puddle then soak pad in liquid and you're ready to coat!
Unhook the trigger and slowly squeeze the handle 10 times until the applicator pad is soaked.
Lift up the applicator, let the liquid puddle then soak pad in liquid and you're ready to coat!
Clean up & storage
Clean nozzle and main unit after every use to prevent clogging. Rinse under running water until it runs clear then let dry.
Store in a cool, covered area. Unused Cabot's EasyDeck™ coating can be stored for up to a year.
Wait at least 40 days between uses. Cabot's EasyDeck™ is recommended for use between normal recoat cycles of Cabot's Aquadeck®. Allow at least 30 days after reapplying Aquadeck® to use Cabot's EasyDeck™.
Clean nozzle and main unit after every use to prevent clogging. Rinse under running water until it runs clear then let dry.
Store in a cool, covered area. Unused Cabot's EasyDeck™ coating can be stored for up to a year.
Wait at least 40 days between uses. Cabot's EasyDeck™ is recommended for use between normal recoat cycles of Cabot's Aquadeck®. Allow at least 30 days after reapplying Aquadeck® to use Cabot's EasyDeck™.
What you’ll need
Ensure that you are holding and then releasing handle in between each pump to allow the value to open up completely to let the liquid out and then ensure pad is completely covered with liquid before you begin.
The EasyDeck system is designed to be used frequently to maintain your outdoor timber deck, removing dust, dirt and debris and leaving you with a freshly coated finish ready for entertaining. EasyDeck can be used monthly.
The applicator pad is designed to trap dust and keep it trapped whilst allowing the Maintenance Coat to flow through onto the deck.
EasyDeck™ will not change the base colour of your timber. It's designed to enhance the existing colour of your decking, providing an aesthetic refresh in the process.
EasyDeck™ will alter the finish of solvent based products so is not recommended for use with solvent/oil-based products.
The system is compatible with use on top of water-based coatings such as Cabot's Aquadeck.
EasyDeck™ cannot be used on new/bare, grey, patchy, or worn timber. It is designed for use over existing water-based coatings that are in good condition.
EasyDeck™ cannot be used on grey, patchy, or worn timber.
The system can be used on lightly damp timber, but it will not work on pooled water.
At least 30 days.
40 minutes for heavy foot traffic.
The applicator can still be used in direct sunlight and hot weather conditions, but you may experience some spreading issues due to the coating drying too quickly.
There is no need to clean or sand before use. You should brush your deck prior to using it, to remove larger debris and sport clean where appropriate.
Furniture items that you don't typically move can be left, and smaller items that you move frequently, like chairs, should be removed to avoid uncoated patches.
It will get mixed with a coating or get trapped under it. For very large stains, we recommend using Cabot's Everyday Deck Wash prior to coating.
If needed, you can cut around the edges by hand using the applicator pad. However, being a maintenance system, this step is not required.
No. The Cabot's EasyDeck™ Maintenance Coat does not protect your timber. It is designed to restore the look of your timber and is intended to be used between recoats with a water based decking oil such as Cabot's Aquadeck. Look out for signs of cracking, splitting, greying, or water no longer beading on top of the deck to know when it's time to recoat with a decking oil.
The applicator may be clogged due to improper cleaning after prior use. Try to remove the bottle and reinsert it. If the issue persists, flush the pump mechanism with hot running water while pumping the yellow levers.
No. The system is only compatible with the Cabot's EasyDeck™ Maintenance Coat. The applicator pad and pump mechanism are calibrated to the coating's specific viscosity and formulation to ensure optimal application experience. Using other water based coatings may cause an uneven finish and reduced film build, compromising the protection of your deck. The use of solvent based products will chemically degrade the plastic components of the applicator, leading to failure and potential leakage.
At least 30 days.
We are proud to offer a three year warranty for the applicator unit. If you experience any issues with your purchase, submit a warranty claim form through cabots.com.au/warranty, and one of our friendly customer service representatives will be in touch.